Trailing Point Hunter

A five-inch feather patterned Damascus blade forged from 1075 and 15N20 steels is featured on this hunter.  The 416 stainless steel guard and handle bolts are engraved by maker.  The handle is fashioned from India stag.  

Sharp By Coop Photo

Trailing Point Hunter

The four-inch Damascus blade is forged from 1075 and 15N20 steels in a W-pattern.  The fittings are made from 416 stainless steel.  Sheep horn is featured on the handle.  This knife is available in carbon steel also.   

Steve Woods Photo

Drop Point Hunter

This knife is shown with a 4 1/2 inch blade in a forged from 1084 steel.  It has a 416 stainless steel guard and pins engraved by Terry Theis.  The handle is sheephorn. 

  Chuck Ward Photo

Spirit of the Wild Hunter

The four-and-one-half-inch Damascus blade is forged from 1075 and 15N20 steels.  The fittings are made from 416 stainless steel by Steve Dunn.  India stag is featured on the handle.  This knife is available in carbon steel also.   

Chuck Ward Photo

Damascus Hunter

 A W-patterned 4 1/2 inch blade from 1075 & 15N20 steels is featured on this hunter.  The fittings are made from 416 stainless steel and feature engraving by Terry Theis.  The handle is fashioned from mammoth ivory.  

Eric Eggly, PointSeven Studios Photo

The Pear Flat Special

This model has a 4" semi-skinner blade available in carbon steel or Damascus. The piece is shown with stainless steel fittings and an India stag handle. A very functional design.

McKee Scan.